Simpson Strong-Tie 1/2 Inch Lipped Drop-In Anchor with 5/8 Drill Bit Diameter

Simpson Strong-Tie 1/2 Inch Lipped Drop-In Anchor with 5/8 Drill Bit Diameter

The Simpson Strong-Tie 1/2 Inch Lipped Drop-In Anchor with 5/8 Drill Bit Diameter provides easy installation into base materials. The improved geometry in the expansion plug improves setting capability. This expansion anchor is easily set by driving the plug toward the bottom of the anchor using in hand or power-setting tools.

Features:

• New design offers easier installation than previous drop-in anchor design – sets with fewer hammer hits
• Positive-set marking system indicates when anchor is properly set
• Lipped drop-in version available for flush installation
• Hand- and power-setting tools available for fast, easy and economical installation
• Fixed-depth stop bit helps you drill to the correct depth every time

Specifications:

• Material: Carbon Steel
• Finish: Zinc-Plated
• Rod Size: 1/2 in.
• Drill Bit Diameter: 5/8 in. 
• Bolt Threads: 13 per in.
• Body Length: 2 in.
• Thread Length: 3/4 in.

Manual Installation:

1. Drill a hole in the base material using the appropriate diameter carbide drill bit or fixed depth bit as specified. Drill the hole to the specified embedment. For fixed depth bits drill the hole until the shoulder of the bit contacts the surface of the base material. Then blow the hole clean of dust and debris using compressed air. Overhead installations need not be blown clean.
2. Insert the anchor into the hole. Tap with hammer until flush against the surface.
3. Using the designated Drop-In setting tool, drive expander plug towards the bottom of the anchor until the shoulder of the setting tool makes contact with the top of the anchor. When properly set 4 indentations will be visible on the top of the anchor indicating full expansion.
4. Insert bolt or threaded rod. Minimum thread engagement should be equal to the nominal diameter of the threaded insert.

SDS Installation:

1. Drill a hole in the base material using the appropriate diameter carbide drill bit or fixed depth bit as specified. Drill the hole to the specified embedment. For fixed depth bits drill the hole until the shoulder of the bit contacts the surface of the base material. Then blow the hole clean of dust and debris using compressed air. Overhead installations need not be blown clean.
2. Insert the anchor into the hole. Tap with hammer until flush against the surface.
3. Attach the SDS Drop-In setting tool to a drill. Drive expander plug towards the bottom of the anchor using only hammer mode until the shoulder of the setting tool makes contact with the top of the anchor. When properly set 4 indentations will be visible on the top of the anchor indicating full expansion.
4.  Insert bolt or threaded rod. Minimum thread engagement should be equal to the nominal diameter of the threaded insert.